Turntable accessories - Needle life - Adjustment
"Somehow it doesn't sound quite right any more. When did I last change the needle?" Anyone who listens to records regularly will be familiar with this thought - and usually pushes it aside because there is simply no answer. Operating hours add up unnoticed over months and years. The Analogis Stylus Timer puts an end to this: it precisely counts the actual playing hours of your cartridge - and finally gives you the certainty of when a stylus change is really due.
It sounds like a small thing - but it's not. A worn stylus doesn't just sound worse. It actively causes damage: the worn diamond loses its precise grinding geometry and grinds itself wide instead of plunging precisely into the groove. The result is mechanical damage to the groove structures that cannot be reversed - not even with a new stylus. The Stylus Timer therefore not only protects the sound, but also your entire record collection.
Precise hour counting
Accumulates every minute of playback - you can see the exact operating hours of your stylus at any time
Conceivably simple
Start when lowering the tonearm, stop when raising it - it doesn't get any easier than this
Aluminum front housing
Elegant housing with aluminum front - free-standing or for wall mounting, with folding stand
Why needle wear is so critical
A new diamond cut is precisely geometrically shaped - elliptical, shibata or spherical - and touches the groove walls at precisely defined points. This geometry wears away with increasing cutting time: The diamond becomes rounder, the contact point moves, the contact surface increases uncontrollably. What follows are distortions, lost high-frequency details and a dull, hazy sound - signs that are often blamed on other causes because you simply don't know how many hours the needle has been in the groove.
As a rule of thumb, a stylus should be replaced after around 1,000 hours of operation - earlier for some systems with lower compliance, and possibly a little later for high-quality special cuts. If you listen to records for two hours a day, you will reach this limit in just under a year and a half. Without a counter: pure guesswork. With the Stylus Timer: exact knowledge and timely replacement before damage occurs.
The operation of the Stylus Timer is consistently reduced to the essentials: press Start when the tonearm is lowered - press Stop when it is raised again. That's it. The LCD display reliably shows the accumulated hours. An important note about the display: The device counts in full hours - in the first hour the display appears to be blank, only after 60 minutes of playing time does the first digit appear. This is not a defect, but intentional. Batteries (AAA) are not included.
The elegant housing with aluminum front panel fits professionally next to any record player - a clear, functional design that does not distract from the essentials. A fold-out stand enables free-standing operation on the shelf, while a suspension device makes discreet wall mounting possible as an alternative. The Stylus Timer is one of those products that you wish you had discovered much earlier.
| Manufacturer: Analogis |
Analogis |
| model |
Stylus Timer |
| function |
Cumulative operating hours counter for pickup needles |
| Display |
LCD display, display in full hours (first digit after 60 min.) |
| Operation |
Start / Stop by button |
| Power supply |
AAA battery (not included) |
| Housing |
Elegant with aluminum front panel |
| Installation |
Free-standing (folding stand) or wall-mounted (suspension device) |
| Recommended stylus life |
Approx. 1,000 operating hours (depending on cartridge) |
| Suitable for |
All turntables - universal use |