Audio Accessories · Banana Plugs
A speaker connection is only as good as its weakest contact. Banana plugs that work loose after being plugged in a few times, or bare strands that oxidise and fray, cost nerves and signal quality. The Dynavox banana plugs with expanding lock solve this problem. An expanding pin spreads the plug inside the socket and ensures a firm, lasting contact at both amplifier and speaker.
The principle is simple and effective. The pin is screwed into the plug shaft from the rear, pushing it apart. Sprung contacts can lose tension over time, whereas the tension of the expanding pin can be readjusted at any time. The cable itself is clamped without soldering by two set screws, and the 24-carat gold plating protects the contact surfaces against corrosion.
Expanding Lock
The expanding pin spreads the plug. It sits firmly and can be readjusted at any time
Solderless Installation
For cables up to approx. 4.5 mm in diameter, clamped with two set screws
24K Gold-Plated
Corrosion-protected contacts with red and black colour coding
The two set screws distribute the clamping pressure over a longer stretch of the strands than a single screw. The cable therefore sits centred, firmly and with a large contact area inside the plug. At the other end, the expanding pin holds the plug in the socket. Both junctions stay stable, even when the cable is moved or replugged often.
Gold does not oxidise. The gold-plated contact surfaces therefore keep their low contact resistance for years without the plugs needing to be cleaned. The red and black colour coding is more than cosmetic. Swapping plus and minus runs a speaker out of phase. The result is thin bass and a diffuse soundstage. With the coding, this mistake simply doesn't happen.
No soldering iron is needed. Strip the cable so that the strands reach the end of the clamping chamber, and twist the wires neatly. Then insert the strands and tighten both set screws evenly. Finally, screw in the expanding pin from the rear until the plug sits noticeably tight in the socket.
A tip from practice: do not tin the strands before clamping. Tin yields under the pressure of the screws over time, and the connection loosens. Bare, twisted copper strands hold permanently. To be on the safe side, retighten the set screws after a few weeks.
The set contains four plugs, two with red and two with black marking. That is enough for one speaker cable with plugs at both ends or for a stereo cable pair with plugs at one end. To terminate both cables of a stereo pair at both ends, you need two sets. Bi-wiring requires correspondingly more.
The plugs accept cables up to approx. 4.5 mm in diameter. Please check your cable briefly before ordering. The set is supplied in blister packaging.
| Manufacturer |
Dynavox |
| Type |
Banana plug with expanding lock |
| Fixing in the socket |
Expanding pin, screwed in from the rear |
| Cable attachment |
2 set screws, solderless |
| Cable diameter |
up to approx. 4.5 mm |
| Finish |
24-carat gold-plated |
| Colour coding |
2× red, 2× black |
| Contents |
4 pieces |
| Packaging |
Blister |