Side force (skating) at the tip and the method of adjusting the compensation of this force.
1. generation of lateral force at the tip
When playing a disc, the tip is passed through a spiral groove where the audio is recorded. In addition to the vertical force, the tip is also subjected to a frictional force that has a direction tangential to the groove. One component of this force acts in the direction of the connection of the tip and the pivot point of the transmission arm and is absorbed in the bearing of the arm. The second component acts perpendicular to it and attempts to rotate the arm toward the center of the board. As a result, the peak pressure on the inner wall of the groove in which the left channel is received is greater than on the outer wall of the groove in which the right channel is received. Balancing of these forces is achieved by introducing a balancing force that attempts to rotate the arm in the direction of the circumference of the platen. Depending on the design of the turntable, this force is exerted by a weight or an electromagnet, but most often by a spring. Usually, the adjustment of the lateral force has the same scale as the vertical pressure on the tip, and if the same numerical value is set as for the pressure, its magnitude will be close to the optimal value even without other aids. However, this does not mean that the pressure on the gear has the same value as the set lateral force. This force is much smaller and only to simplify the operation of the turntable, both scales are the same.
Set the horizontal position of the turntable.
The device must be placed on a solid base, where no vibrations are transmitted from the environment. Wall shelves or solid stainless steel tables are suitable. The horizontal position is set with a commercially available spirit level on a turntable or a spherical spirit level.
3.Adjusting the balancing force (antiskating)
With this test plate without grooves - the so-called mirror - you can set a suitable balancing force without additional measuring equipment.
- Check the horizontal position of the unit with a spirit level.
- Set the vertical force and the balancing force to zero - the portable "floats" in the air and should stay above the plate wherever we set it.
- If we blow gently on the arm from the side, it should spin freely.
- Set the vertical force on the tip according to the specifications for the particular type of insert and the tip in the upper third of the range specified by the manufacturer.
- Turn on the turntable and lower the transfer arm to a smooth plate near the perimeter. The portable unit is pushed to the center of the board.
- We add the balancing force until the transfer stops on the board surface. Ideally, the portable device will stay anywhere on the board where we place it. In other cases, it is enough to achieve stabilization in about half of the surface.