Record Restore - Record Reactivator - 4 bottles - Secret Chord Analogue

FAQ & tips - Frequently asked questions and useful tips

How do I clean records properly?
The secret is that nothing should be left in the groove after cleaning. Sounds simple - but it's not. A higher standard than "just cleaning" is necessary if music is to be played with the highest fidelity. After treatment, the record should be silent: You hear nothing but the music - no pops, no hisses, no pops - provided the record is physically intact.

Why should I worry about dust on my records?
Apart from sound degradation, dust and dirt on the record costs money. Dust, grains of sand and particles removed by the cartridge can not only damage the record, but also wear out the stylus faster and change the sound. Many of these particles are harder than the material of the record and can cause micro-scratches. A worn stylus can also cause permanent damage, resulting in reduced detail reproduction.

What causes unwanted noises on records?
Crackling, crackling records are often wrongly described as "scratched". In fact, it is usually dirt or "crud" in the grooves - i.e. dust, deposits and particles that have become lodged. Analyses show that these contaminants consist of silica particles, abrasion, soot, fibers and also binding agents that keep these particles on the surface. Greasy substances, oils, nicotine or skin oils act as binding agents, causing dirt particles to stick to the grooves.

Do all records benefit from cleaning?
Yes, both new and used records benefit from a thorough treatment. New records may initially appear clean, but often carry residues of press-release substances and static charge. Older or heavily played records usually have a lot of contaminants that have accumulated over the years.

Are all record cleaning methods essentially the same?
No. The only acceptable standard is a method that removes everything from the groove: particles, binding agents, static charge, residues. Brushes and cloths reach their limits here because they only have a superficial effect. Only a method that penetrates deep into the groove, dissolves impurities and neutralizes static charge is really effective.

Why is Record Restore so good at cleaning records?
The challenge lies in completely removing the mixture of particles and binders from the groove. Record Restore breaks up oily and greasy binders and emulsifies them, dissolving the particles. During drying, a film structure is formed in which all impurities are trapped - this film shell can then be removed. This removes 100% of the dissolved components without leaving any residue.

What is the best method for cleaning vinyl records?
If your goal is to really remove everything from the groove and eliminate static, then Record Restore is the answer. Only Record Restore combines the complete removal of dissolved impurities with simultaneous neutralization of static charge - all in one step.

What are the benefits of Record Restore?

• Prevents static charge - fine particles are not attracted

• Restores fidelity and eliminates noise

• Extends the life of the stylus - your records and cartridges are protected

• Extremely practical - requires no electricity, can be used in small spaces

• Easy to use, no mess, batchable - about 3 minutes per record

• Unlike conventional water methods, Record Restore leaves no residue behind

Why is static electricity bad for records?
Static charge on a record can discharge through the cartridge, creating pops and hiss. In addition, a static charge attracts fine particles flying around, which then get stuck. As long as the charge is not neutralized, such particles cannot be effectively removed. Record Restore removes static charge permanently - this prevents new contaminants from sticking.

How does Record Restore tackle static electricity?
Record Restore's formula is designed to neutralize statically charged particles. As long as there is a charge, particles are difficult to remove - they literally "stick" to the groove. By neutralizing these adhesive forces, even the finest particles can be removed. Record Restore therefore not only ensures thorough cleaning, but also prevents new sources of noise.

Why is Record Restore particularly suitable for old record collections?
Record Restore is ideal for restoring extensive and older collections. The box set allows up to 10 LPs to be processed simultaneously - in an area of only around one square foot. It works without electricity, without noise and without chemical mixing. Once you have internalized the process, you can treat a batch of ten records in about half an hour (without drying time).

How easy is it to use the Record Restore Box Set?
Many people neglect record care because they shy away from the effort involved. With the Box Set, the setup is done in less than a minute and takes up very little space (e.g. a coffee table surface). Whether one or ten plates - the effort remains minimal. Cleaning is not messy, there are no aqueous solutions that could splash. And cleaning up often only takes two minutes, including cleaning the brush.

What is the safest way to clean/restore old 78 rpm records?
The older 78 RPM records are usually made of delicate Shellac, which should not be treated with conventional vinyl compound. That's why Record Restore has a special formula that is safe for both Shellac and vinyl and will not harm the surface.

Delivery
Our standard delivery is free of charge from:

• Germany 90,- €
• Austria 200,- €
• Switzerland 300,- €

Return shipment

• A return shipment from Germany costs € 5.90

Please register your return with us, then you will receive a return slip by e-mail. This ensures that the return is always sent to the correct address.

The delivery times can be found in the delivery status display on the item. Click here for the detailed delivery status display.